TITLE: Testing and troubleshoot the circuit
OBJECTIVE:
To test the circuit and identify the problem occurred during troubleshooting
To test the circuit and identify the problem occurred during troubleshooting
DISCUSSION/ANALYSIS:
At this week, I test the circuit with my advisor, Mr. Suhairi using the oscilloscope. By using the hall sensor, I attach the probe of oscilloscope to one of the hall sensor signal leg. As the hall sensor get supply from the battery, it should working properly. By using a magnet, I test the circuit driver to get an output signal. Below is the result of my testing. The result that I get is only for one phase. I can only get result for 3 phase if I test the circuit with the BLDC motor.
Connection of circuit and oscilloscope
At this week, I test the circuit with my advisor, Mr. Suhairi using the oscilloscope. By using the hall sensor, I attach the probe of oscilloscope to one of the hall sensor signal leg. As the hall sensor get supply from the battery, it should working properly. By using a magnet, I test the circuit driver to get an output signal. Below is the result of my testing. The result that I get is only for one phase. I can only get result for 3 phase if I test the circuit with the BLDC motor.
Connection of circuit and oscilloscope 
Result of the testing
CONCLUSION:
I had successfully design and fabricate the circuit driver for 3 phase BLDC motor as I get the output result from the testing.
I had successfully design and fabricate the circuit driver for 3 phase BLDC motor as I get the output result from the testing.
No comments:
Post a Comment