TITLE:
Soldering components
Soldering components
OBJECTIVE:
To attach the components with the PCB Board.
To attach the components with the PCB Board.
DISCUSSION/ANALYSIS:
After finished fabricate my PCB Board last week. I start to attach the components with the PCB Board. It seems like easy to me at first but actually it a little bit hard. I need to identify the polarity of the components. If I make the wrong identification it will affect my circuit driver. The circuit driver will not work properly. This week, I already soldering about 90 percent of the components to the board. Another 10 percent I will done it next week because I had misplace some of the components. I need to go to Jalan Pasar first to buy it and then complete the circuit.
After finished fabricate my PCB Board last week. I start to attach the components with the PCB Board. It seems like easy to me at first but actually it a little bit hard. I need to identify the polarity of the components. If I make the wrong identification it will affect my circuit driver. The circuit driver will not work properly. This week, I already soldering about 90 percent of the components to the board. Another 10 percent I will done it next week because I had misplace some of the components. I need to go to Jalan Pasar first to buy it and then complete the circuit.
CONCLUSION:
I not successfully attached the components to the PCB Board due to misplace of some of the components.
I not successfully attached the components to the PCB Board due to misplace of some of the components.
No comments:
Post a Comment